Custom etched shims

Etched shims are thin metal spacers cut by chemical etching instead of stamping or laser cutting. They are burr-free and flat, so a stack of shims measures exactly the sum of its parts. We etch custom shims to drawing in stainless steel, brass, copper and spring steel from 0.05 mm thick, in any outline and from a few pieces upward.

Diagram of a chemically etched shim with a centre hole, open slot and thickness marking, next to a side view of a stack of shims from 0.05 mm to 0.50 mm
An etched shim with its thickness marked on the part, and a shim set built up from several thicknesses.

Why shims are etched

  • No burrs. A stamped or laser-cut burr adds height to the shim and stops a stack from seating. Etched edges have none, so no deburring is needed.
  • Flat and stress-free. No punch force and no heat, so thin shims do not dish or curl.
  • Any outline, same price. Slots, bolt-hole patterns, tabs and internal cut-outs are all etched at once.
  • Identification on the part. The thickness or part number can be etched into the surface in the same run, so shims are not mixed up during assembly.
  • No hard tooling. A set of shims in several thicknesses uses one phototool, not a die for each.

Materials and thickness

MaterialTypical gradesUsed for
Stainless steel301, 304, 316LGeneral machinery, food and chemical equipment, corrosion resistance
Spring and carbon steelC75S, SK5Hard, wear-resistant shims and spacers
BrassCuZn37 / C2680Easy to fit, non-sparking, general alignment
CopperC1100Electrical and thermal contact shims
Aluminium1060, 5052Lightweight spacers

Thickness range is 0.05 mm to 5.0 mm. Common shim thicknesses are 0.05, 0.10, 0.15, 0.20, 0.30 and 0.50 mm. The thickness tolerance of a shim is that of the rolled strip; the outline and hole positions are set by etching. Tolerance can be held to ±0.01 mm, depending on material thickness and part size.

Spray etching and rinsing line in the Golden Eagle workshop
A spray etching and rinsing line in our workshop. Sheets pass through flat, which keeps thin shims flat.

Typical shims we etch

Motor and gearbox adjusting shims, bearing shims, alignment shims with open slots, shim washers and rings, valve and pump spacers, mould shims and matched shim sets in graded thicknesses.

What to send for a quote

The drawing, material and grade, each thickness required and the quantity per thickness. If shims are to be supplied as a kit, tell us how they should be packed and marked. Related: spring steel etching, what chemical etching costs and prototype service.

Request a quote

Send your drawing in DXF, DWG, STEP or PDF format with the material and grade, thickness, quantity and required delivery date through our contact page. We check manufacturability against the drawing before tooling. Sample lead time is typically 3 to 7 working days. Drawings are treated as confidential.

Etched shims: FAQ

How thin can an etched shim be?

We etch shims from 0.05 mm thick. Because there is no cutting force, even the thinnest shims stay flat and undamaged.

Are etched shims burr-free?

Yes. The metal is dissolved rather than sheared, so there is no burr on either face and shims stack to their true combined thickness without deburring.

Can the thickness be marked on each shim?

Yes. Thickness, part number or a logo can be half-etched into the surface in the same run as the outline, at no extra processing step.

What is the minimum order for custom shims?

There is no hard tooling, so small batches and prototype quantities are practical. Cost per piece falls as quantity rises because more shims are nested on each sheet.

Scroll to Top