Decorative Metal Etching
Decorative metal etching for architectural panels, elevator trim, signage and interior design elements in brass, stainless steel and copper.
What this service covers
Decorative Metal Etching is carried out by photo etching. A photographic resist is applied to the metal sheet, the pattern is transferred by exposure and development, and the unprotected metal is dissolved by a controlled etchant. The result is burr free detail, repeatable tolerances and no tooling cost for complex shapes, which makes it well suited to prototypes, short runs and intricate geometries that are difficult to machine.
Materials we etch
We etch brass, copper, aluminium, 304, 316 and 302 stainless steel, nickel, titanium and low carbon steel. For every material we select the etchant and process window that avoids distortion, hydrogen embrittlement and excessive undercut, so hole size, wall thickness and flatness stay within specification across the batch.
Industries served
Industrial equipment and instrumentation, automotive and rail, electronics and control panels, oil and gas filtration, architecture and interior decoration, medical and laboratory equipment, and identification and signage. Parts are commonly supplied as nameplates, data plates, screens, meshes, filters, gaskets, stencils, shims, washers and decorative panels.
Key technical parameters
Etched thickness typically ranges from 0.05 mm to 1.0 mm. Minimum feature width and minimum web depend on material and thickness, and we confirm manufacturability against your drawing before tooling. Tolerance on the etched profile is typically plus or minus 0.1 mm to 0.2 mm depending on part size and process. Parts are supplied deburred, cleaned, and passivated where the material and application require it.
How to request a quotation
Send the drawing in DXF, DWG, STEP or PDF format together with the material and grade, the thickness, the quantity and the required delivery date. We will confirm feasibility, propose the process and return a quotation. Sample lead time is typically 3 to 7 working days, and batch production timing depends on volume and current capacity. Drawings are treated as confidential and are not shared with third parties.
Read the frequently asked questions below for materials, tolerances, lead times and ordering.
Related resources
Decorative Metal Etching — FAQ
What decorative finishes can chemical etching produce?
The pattern can be left as bare metal, filled with paint for contrast, or a combination of both. Because the process is subtractive, the artwork can include fine line work, gradients of line density, photographic tonal effects and complex repeats that would be impractical with mechanical engraving.
Which metals are most used for decorative etching?
Brass is the traditional choice for signage and decorative panels because of its warm colour and the way it takes the etched finish. Stainless steel is used where a contemporary monochrome look or high durability is needed, and copper gives a distinctive warm red-brown that suits feature walls and signage.
Can decorative panels be large?
Yes, panels are produced in flat blanks and can be large. The practical limit is the size of the available sheet and the flatness of the material, so large panels are often supplied for a later frame or fixing stage.
How do you fix decorative panels to a wall?
Fixing is normally by a building method such as a concealed frame, stand-off bosses or a bonded backing. We can produce the panel with the required holes, slots or a rebate, and discuss the fixing method before production so the panel is made to suit it.
Are the patterns copyright protected?
We work to the artwork you supply, so responsibility for the rights to the design rests with you. We are happy to work from a licensed design, a photograph you own, or an original piece.